Reviews

Insanity Automation

4.7/5(24 reviews)

Great prints. However, took longer than most I've ordered from on treatstock.

Awesome prints! Thanks again!

Great. I'll continue more purchase on here

Good print. Thank you

Layer Resolution: 50 micron - 500 micron Infill: 20% (default) Material & Color: PC Black I needed to print a replacement part for the Steam Controller right bumper. Apparently this is a common failure for the controller. I took a blind guess that the polycarbonate print would be strong enough, but it wasn't. The same part that failed before snapped off. Also, the tolerances were a bit off. I had to bore out 2 holes a little larger so that a metal shaft from the controller would fit. I also had to sand down a couple pegs on the reverse side so that the part would fit into the controller. It was during my handling the part with a filer that the part snapped. I don't really blame anyone for this, but it still sucks. I wonder if I wouldn't have had any of these problems if I had printed in a different material or tolerance. 0.5 mm seems a bit large now that I think about it. Oh well. I'll probably try to epoxy it together later.